Technology of Placing gypsum tiles with your own hands – Muhammadi Sweets

Technology of Placing gypsum tiles with your own hands Leave a comment

Gypsum tiles have to be laid properly, as not just the aesthetic appearance of cosmetic facing, but also the service quality of

the substance will rely on the engineering of job. The product is also universal, and it can be connected to plaster, concrete,

brick or gypsum board sheets, provided that the top layer of the base is and has no defects.

If the defects of the base are significant, it should be thoroughly treated with primer, and then a cement mortar is made, which

matches all of the cracks. Subsequently the surface ought to be primed and dried. Primer treatment is essential to improve the

bond between the tile and the walls. In this case, its makeup should choose a particular, comprising elements which block the look

of fungus and mould.

In the modern interior of these rooms most frequently used gypsum tiles, imitating natural stone or brick. To perform decorative

finishing yourself, it is essential first of all to pick a scheme of tile positioning and prepare a solution. It is important to

look closely at the reverse side of the substance. When its surface includes an embossed surface, then the glue ought to be placed

using an trowel, and if it is even, then using a top notch one.

The technology of this job is as follows:

* A thin layer of glue is placed on the pre-prepared wall. It’s spread over the base so it is likely to place 4-5 tiles.

Decorative cladding may be placed both on plasterboard, and on putty.

* Cover the rear side of these tiles with glue.

* Plaster elements are pushed against the wall and their place is adjusted. To align the seams, it is recommended to use

spacers.

* Finishing is carried out in rows, all which should be shifted by half of a tile. Facing is completed to the corners of this

space, and then immediately remove any remaining mortar at the joints.

Drying the walls takes no longer than a day also demands a continuous humidity and temperature inside the room. The final point in

the placing of gypsum tiles is the decor. To get this done, the joints between these components are full of a particular solution,

the color of which matches the brick.

Cosmetic fake of brickwork around the walls has been carried out in the following manners:

* Cutting on the plastered surface of the stitches of masonry using a bolt cutter with your own hands;

* placing of tiles under the brick:

* mimicking the structure and color of the side of one brick;

* Imitating a fragment of brickwork of many bricks.

The very best method to decorate”beneath the brick” is the one which permits you to create a usable coating together with the most

look of its resemblance to natural masonry. All three approaches to perform this kind of finishing works meet the demands,

however, the cutting edge of joints using a bolt is more labor-intensive and also the formation of large amounts of dust, so let

us consider more ordinary ways.

The old finish is removed from the walls, and the outside, if needed, is leveled to eliminate the requirement to paste plaster

onto a thick layer of glue.

Combining such cladding with other types of interior finishes may be both systematic and performed with no apparent consistency,

chaotically, with fake of signs of aging masterfasada.ru.

With the help of decorative gypsum tiles it is possible to mimic a lot of textures.

A large number of textures could be imitated with the help of decorative gypsum tiles.

The wall where it is to be installed should have the following characteristics:

* Hardness and strength of the surface;

* The absence of irregular areas and sharp sections;

* not any deformations.

Cosmetic tiles at the interior of the kitchen

Walls are created from a number of substances, so let us break down the individual rules of installation.

When dealing with concrete, there will be no big problems. It is just essential to take into consideration the porosity of the

material. Concrete, that has practically no pronounced pores, should be treated with a great primer.

Mounting gypsum tiles concrete

Before starting work on the setup of gypsum tiles to the walls, then it is worth checking the strength of this surface. After the

plaster does not fall off the wall and in the exact same time holds nicely, it’s possible to simply paint it using primer.

Mount the tiles on the painted concrete should not. The surface ought to be scratched, making sure to misfire, and it ought to be

grouted and coated with a layer of plaster.

Leave a Reply

Your email address will not be published. Required fields are marked *