Characteristics of polycarbonate greenhouse Harvest PC – Muhammadi Sweets

Characteristics of polycarbonate greenhouse Harvest PC Leave a comment

The thickness of the material is 4 mm.

If you want, you can increase the amount of the construction to 6 metres or more. To do this, it’s enough to attach a two-meter extension. When selecting a drawing, focus on the space between the arches. This figure needs to be 65 cm, and which is the most appropriate duration for the specified thickness of the material. The width of the doors in line with the manufacturer’s drawing is 90 cm.

Before building a polycarbonate greenhouse, it is necessary to select a place because of its place. If that is done properly, it is possible to provide yourself with a crop of fresh vegetables for the entire year.

The location for the upcoming greenhouse is marked instantly in the planning of the garden plot. So as to melt the snow in the location of the greenhouse as soon as possible, the best point on the site will be a slight elevation. Additionally, in such a location is not going to have to be concerned about higher humidity as soil and air within the structure.

Assemble a polycarbonate greenhouse on an elevated site – intends to look after the optimal temperatures indoors.

If it isn’t feasible to place a greenhouse in an elevated place, you’ll need to pour a coating of fine crushed stone about 20 cm and the exact same layer of fertile soil to make seedbeds.

Before assembling a greenhouse in your backyard plot, you should also think about where and how this structure is going to be set up. To begin with, you must choose a location for this. The greenhouse should be located at a well-lit area no less than a few meters away from houses, barns and other structures.

The best way to Put in a greenhouse in Line with the sides of the Planet

Make sure you measure the dirt surface – it is ideal to remove the top layer. This can also get rid of weed seeds. And for ease of work, eliminate the soil in an area that’s about a meter wider on both sides of the rectangle that you want.

Additionally, it is worth thinking about having a foundation. As manufacturers say, now most greenhouses don’t need that, especially if they (greenhouses) are utilized only in the summer and spring time. However, experienced gardeners still recommend earning a basic foundation from a bar. It is quite simple – it is enough to connect with each other utilizing metal corners and screws four parts of timber using a cross-section of at least 10 * 10 cm. The size of such a base should be equivalent to the foundation of their future greenhouse.

Simple bar foundation

You may even produce a strip foundation of concrete. He’s more dependable than a pub base, but demands more fiscal and labour costs. Incidentally, the greenhouse, that will be used in winter, without it and don’t do with it at all.

Stages of the creation of a strip foundation: a schematic representation

Many producers counsel to install greenhouse structures without even building a foundation. Even for this intention, they equip the framework with special T-shaped legs, so the construction was securely fixed. But, as practice shows, it is still crucial to build a base: therefore and the foundation will be more rigorously fixed and also the components of the foundation in touch with the soil, will be saved much longer in its initial condition.

The principal issue is to see to the material with special agents to protect the timber from moisture. The substance is installed on concrete cubes which are dug into the ground. For a six-meter arrangement, they want 10 bits: four to either side and one in the center of the ends.

Before you do the greenhouse , you will need to choose the right spot for it. It has to be an even website, so the frame was found evenly, without distortions. It should be bright and not obscured by trees or buildings.

Leave a Reply

Your email address will not be published. Required fields are marked *